dielectric breakdown
基本解释
- [电子] 介质击穿
英汉例句
- Dielectric breakdown of BST thin films prepared by RF sputtering is studied in this paper.
采用射频溅射制备BST薄膜，研究了薄膜的介电击穿特性。 - The exact determination of the breakdown voltage must therefore be attached to the measurement of an electrical value characteristic of the dielectric breakdown phenomenon.
因此击穿电压的检测必须重视电介质击穿现象的电参数值的测量。 - Based on analyses in line with the solid dielectric breakdown theory, it concluded that it takes a long time for a partial fault to develop gradually to the dielectric breakdown.
通过固体电介质击穿理论的分析，提出由局部性缺陷发展逐渐导致介质击穿需要较长的发展时间。
双语例句
词组短语
- dielectric surface breakdown 介质表面击穿
- dielectric breakdown strength 电介质哗强度;耐电压强度;绝缘破坏强度;电介质破坏强度
- dielectric breakdown detail 电介质击穿
- dielectric breakdown test 绝缘哗试验;绝缘击穿试验;绝缘破坏试验;击穿电压
- Dielectric Breakdown Model 模型;根据介电击穿模型;介电击穿模型;击穿模型
短语
专业释义
- 绝缘破坏
In this paper, based on the measurement of dielectric breakdown and theoretical analysis, epoxy resin has been employed to investigate the effects of material characteristics and fog parameters on the insulating properties.
本文以环氧树脂为试品,通过对绝缘破坏现象的检测及理论分析,研究盐雾环境下环氧树脂的绝缘破坏特性,考察材料特性与盐雾参数对绝缘破坏的影响。 - 介质击穿
- 绝缘击穿
With decreasing the atmospheric pressure, the discharge quantity increased with PBN, but decreased with PBT. With increasing the total dose, the time to dielectric breakdown increased with PBN, but decreased with PBT.
结果表明:随着辐射量的增加,PBN的放电量减小;而PBT的放电量增加;随着辐射量的增加,PBN的绝缘击穿时间增长,而PBT的绝缘击穿时间缩短;随着气压的降低,PBN的放电量增加,而PBT的放电量减小,它们绝缘击穿时间增加。 - 介电击穿
- 介质崩溃
- 介电击穿
During the and actuation voltages often lead to the wrinkling phenomena and dielectric breakdown of EAP membrane and result in the failure of actuator.
介电型EAP驱动器在工作过程中,边界条件及驱动电压的改变经常导致EAP薄膜发生起皱现象以及介电击穿,致使驱动器失去工作能力。 - 介质击穿
- 介质破坏
- 介体破坏
- 介电击穿
During the and actuation voltages often lead to the wrinkling phenomena and dielectric breakdown of EAP membrane and result in the failure of actuator.
介电型EAP驱动器在工作过程中,边界条件及驱动电压的改变经常导致EAP薄膜发生起皱现象以及介电击穿,致使驱动器失去工作能力。动力与电气工程
- 绝缘击穿
- 介质击穿
- 介质哗